USE: Household pumping stations are used for pumping waste water from low-lying buildings where gravitational flow is not possible. Domestic waste water is collected in the shaft of the pumping station. As soon as the water level inside the shaft reaches a preset value, the submerged centrifugal pump is switched on and waste water is pumped into the sewage system. The household pumping station consists of a shaft, a submersible centrifugal pump, level switches, a non-return valve, a closing valve, and a connection on the pressure pipe and cover.

INSTALLATION: The household pumping station is suitable for installation under surfaces either with or without vehicular access (loads up to 125 kN). After the household pumping station is placed into an excavated pit onto a precompressed layer of sand, the hole for the inlet pipe in the wall of the shaft has to be cut. Then, the mounting pipe fitting has to be installed. After that, the inlet and pressure pipe have to be connected. Exact instructions for installation and assembly are included together with the product

Product

Code

Diameter

[mm]

Height

[mm]

Household pumping station with
non-return valve for installation
under areas with no vehicule acess.

7700010000

1000

1400

Household pumping station with
non-return valve for installation
under areas with no vehicule acess.

7700008000

800

1400

Household pumping station with
non-return valve for installation
under areas with vehicule acess.

7700010001

1000

1400

Household pumping station with
non-return valve for installation
under areas with vehicule acess.

7700008001

800

1400

Household pumping station with
non-return valve for installation
under areas with no vehicule acess
and with two pumps (2x VXm 8/35).

7700010020

1000

1400

Household pumping station with
non-return valve for installation
under areas with vehicule acess
and with two pumps (2x VXm 8/35).

7700010021

1000

1400